Fast & strong concrete repairs for heavy wear, cold areas. Cures down to -20°C
Total price
£267.55 (Ex VAT)
Watco Flowpatch Sub Zero is ideal for concrete floor repair in cold rooms. It will cure very rapidly to withstand heavy traffic, even at -20°C. Ideal for repairing holes or leveling damaged concrete floors.
| Properties | Will cure at minus 20 degrees, easy to use, just add water, mix and apply, magnesium phosphate-based formula, extremely tough |
| Suitable for | Concrete |
| Finish | Smooth |
| Interior or Exterior | Exterior, Interior |
| Composition | Magnesium phosphate cement based powder |
| Coverage | 0.25m² per 10kg at 20mm, 0.6m² per 25kg at 20mm |
| Application tools | Trowel |
| Application | Trowel into hole |
| Curing time (at -20°C) | 5 hours |
| Minimum application temperature | -20°C |
| Pot life | 10 minutes |
| Depth | 20mm |
Remove all loose material including dust, oil and grease. Minimum application depth should be 20mm. Repair edges should be cut to depth to avoid feather-edging. Dampen bare concrete with clean, cold water. Remove any standing water. Briefly warm the area using a blowlamp or gas torch. This helps to accelerate curing.
Warning: do not mix the product for more than 4 minutes. Use immediately. Watco Flowpatch Sub Zero cures very quickly and the mixed product must be applied and finished within 10 minutes.
Mixing must be carried out in an ambient temperature above 5°C. If mixing at temperatures below 5°C, pre-warm the mixing vessel with warm (approximately 25 - 30°C) water. Remove the bag of powder and pour 2 litres of clean, cold water into the plastic container. Gradually add all the powder, mixing thoroughly. Continue mixing to produce a smooth workable mortar.
Trowel Watco Flowpatch Sub Zero firmly into place using a steel trowel or float. The trowel can be wiped with clean, cold water to make finishing easier. Apply the product at a minimum 20mm thickness, if using at a temperature range of - 20°C to 5°C.
£219.00 (Ex VAT)
Low stock
