Long lasting line marking for heavy wear areas
|Properties||Excellent durability, solvent free and virtually odourless, brush applied.|
|Suitable for||Bare concrete, painted surfaces|
|Finish||Mid gloss, smooth|
|Interior or Exterior||Interior|
|Primer required||No primer required.|
|Composition||2 part, water based epoxy resin|
|Coverage||50m of 50mm wide line per litre|
|Number of coats||1|
|Dry film thickness||Approximatley 100 microns|
|Curing time||12 hours at 20°C|
|Minimum application temperature||10°C|
|Maximum operational temperature||60°C.|
|Pot life||Up to 2 hours at 20°C.|
All surfaces should be clean and dry before application. On painted or sealed surfaces remove any poorly bonded material and abrade well bonded paint or sealer to provide a key. A trial area is recommended on smooth, shiny surfaces to test adhesion. Edges of lines should be defined with masking tape.
Thoroughly stir the contents of the smaller resin tin before emptying it into the larger curing agent tin. It is very important that all the contents of the resin tin are decanted and thoroughly mixed with the curing agent with a wide bladed tool until an even colour is obtained.
If appearance is critical we recommend the application of a small trial area first.
Best results are achieved in warm (minimum 15°C), dry conditions with good air circulation. In very high temperatures (30°C and above) it is recommended that bare concrete is lightly dampened first with water. Ideally use a brush and apply sufficient paint to obliterate the substrate. Do not over brush. Remove masking tape 1 to 2 hours after painting.