A chemical resistant coating that cures at 5°C
Chemi-Coat® Cold Cure is a one coat tough industrial paint with excellent durability and chemical resistance. It is suitable for a variety of floor surfaces as well as being solvent free. It provides a superb glossy, hygienic and easily cleaned surface and will cure at temperatures as low as 0°C. It allows refrigeration areas and unheated warehousing to be painted and protected at any time of the year.
|Properties||Cures at temperatures as low as 5°C, suitable for all year round application, strong chemical resistance, low solvent content, excellent durability.|
|Interior or Exterior||Interior.|
|Primer required||Yes on very porous surfaces.|
|Coverage||18m² per 4L pack maximum allowing for one coat by roller. Brush application may result in reduced coverage.|
|Number of coats||1|
|Curing time||48 hours for heavy traffic at 5°C.|
|Minimum application temperature||0°C.|
|Pot life||1 hour at 15°C.|
Concrete and Brick - concrete to be treated must be dry, at least four weeks old and free of any soft surface laitance, contaminants, and not subject to rising damp. All loose material should be removed. Very smooth bare concrete or concrete with soft surface laitance should be etched with Watco Etch & Clean and the area thoroughly hosed off and allowed to dry. Grease or oil should be removed with Watco Bio D (or a similar degreasant) and the area thoroughly hosed off and allowed to dry. Very smooth previously painted surfaces should preferably be abraded to improve adhesion.
Steel - remove loose or flaking material, rust and any previous coatings by wire brushing or disc grinding to achieve a bright surface. Oil or grease should be removed with Watco Bio D and the metal then washed with water and allowed to dry. Coating should be carried out immediately providing flash rusting has not occurred.
Each Chemi-Coat pack consists of a container of curing agent and a container of resin. The curing agent and resin must be very thoroughly mixed together with a wide bladed tool until an even colour is obtained.
Important: Once the contents of the pack have been mixed a chemical reaction takes place which causes a rise in temperature and speeds up the curing of the product.
If appearance is critical we recommend the application of a small trial area first.
Best results are obtained in warm conditions, (minimum 15°C). On horizontal surfaces apply with a medium pile type roller (not foam) in one coat. On vertical surfaces two thin coats are recommended. The second coat should be applied within 24 hours.