A safety surface certified for use in food storage areas
Watco Safety Coat Food Safe uses the latest polyaspartic resin technology for a high quality, highly wear resistant coating that has been tested and has EN71/3 and taint test certification. It will cure in refrigerated areas (down to -10ºC) where other conventional paints will fail to dry.
This is an anti slip version of Watco Food Safe Coating
|Pendulum Slip Test Values|
|Dry PTV||Wet PTV|
|65 Low slip potential||45 Low slip potential|
|Interior or Exterior||Interior and exterior.|
|Coverage||25m² per 2.5L unit.|
|Number of coats||2|
|Curing time||6-8 hours at 20ºC.|
|Pot life||Up to 25-30 minutes at 15°C.|
All surfaces must be -10°C or above and free from ice or water. Concrete to be treated must be at least four weeks old, completely dry and free of contaminants. Grease or oil should be removed with Watco Bio-D (or a similar emulsifying degreasant) and the area thoroughly washed off and allowed to dry.
Very smooth concrete or concrete with surface laitance (a weak dusty layer) should be abraded or etched with Watco Etch & Clean to ensure adequate Adhesion. The concrete should be thoroughly washed down and allowed to dry after treatment with Watco Etch & Clean.
Watco Powerfloat Primer is recommended on powerfloated surfaces but it must be fully cured before overcoating. Previously painted surfaces should be thoroughly abraded by sanding to improve adhesion and to remove any weak or loose material. A trial area is advisable to test compatibility with previous coatings.
Below 5°C it may be necessary to avoid processes which involve wetting the floor due to the difficulty in drying. A good sweep or mechanical brushing may be sufficient.
Mix between 10°C and 25°C. Remove the two inner tins from the tall outer tin. Stir each tin thoroughly and pour all of the contents into the outer tin (scrape around the inside of the tins to remove any residue). Mix the components together thoroughly using a spatula or a similar wide bladed tool (a piece of wooden batten is ideal). Continue mixing until an even colour and consistency are obtained. Do not mix more than one pack at a time. If a paint stirrer fitted to an electric drill is used, use the spatula to blend in any unmixed material from the sides and bottom of the tin. Do not dilute.
If appearance is critical we recommend the application of a small trial area first.
Apply between -10°C and +30°C. The viscosity will be somewhat thicker at lower temperatures, reducing the coverage rates. The product should be worked out with a short pile roller to maximise the coverage and get the best performance from the product.
If you are looking for an attractive smooth finish than you will find it here at Watco. We dont just specialise in Anti Slip, but high performance smooth coatings to.Shop paint
A xylene based solvent to help with cleaning and preparation
From £23.80 (Ex VAT)