Watco Safety Grip is a heavy duty, coarse textured chemical resistant, anti slip two pack epoxy resin coating designed to provide a safe environment inside and out. Using one high build coat of Safety Grip minimises the risk of accidents throughout the workplace, particularly for wet or oily areas. All grades now carry CE Mark EN 1504-2 and have test results for slip resistance, abrasion, scratch and impact resistance, as well as for adhesion and hardness. They are also chemical resistant and have an A+ VOC emissions rating with a low level of VOC.
Also available in Cold Cure, and Flex formulations.
Curing time:
24 hours at 20°C
Ensure that the substrate is free from dust and dirt.
If the concrete is new or bare, remove surface laitance, dust and any light dirt or grease deposits using Watco Etch & Clean. For more preparation techniques tailored to the condition of your floor call our technical advisors on 01483 418 418.
Remove the two inner tins from the tall outer tin. Individually stir the contents of the resin and curing agent thoroughly using a Watco Mixing Blade. Scrape around the inside of the tins to remove any residue.
Pour the mixed components into the larger outer tin and stir thoroughly until uniform in colour. You can then pour the formulation into a shallow Roller Tray ready for application.
Use a Paint Brush for cutting in around the edges. Apply the coating with a Medium Pile Roller (not foam) to a measured area of 5m².
Immediately sprinkle the anti slip aggregate, uniformly, onto the wet coat to obtain the designed surface finish (total or light coverage).
Using the same roller, roll over the sprinkled aggregate to bed in. Do not apply more paint unless very heavy quantities of grit have been applied since this will result in a loss of slip resistance.
