Instant slip resistance for paths and gangways
For a long-lasting, slip resistant surface Surestep Roll is a quick and easy solution. The self adhesive sheet has a tough, resin-bonded aluminium oxide surface with a gritty finish and can be applied in an instant.
You may need Watco Safety Tape Primer for dusty or porous surfaces (two packs per 9.1m x 610mm roll).
|Properties||Slip-resistant, self-adhesive, a heavy layer of water resistant adhesive makes this product ideal for use inside or out.|
|Interior or Exterior||Interior and exterior.|
|Primer required||Yes, on dusty, porous or gritty surfaces.|
Apply to clean, smooth, dry surfaces such as painted or varnished wood, concrete, metal, tiles, and Terrazzo. Apply direct to smooth, hard concrete; dusty concrete will require a primer.
Smooth, non porous, dust free surfaces do not require priming. To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer.
If appearance is critical we recommend the application of a small trial area first.
Avoid application at temperatures below 10°C. Low temperatures can reduce adhesion. On steps and nosings, apply the product approximately 10mm in from the edge to prevent premature wear and edge curl. Peel back the backing strip approximately 50mm to reveal the adhesive layer. Avoid removing too much of the backing strip, but slowly keep peeling it back whilst firming the product into place. Firming down by hand or foot pressure is generally sufficient.
Although the product can be walked on virtually straight away, the adhesive can take 24 hours to set fully. Immediately after placing the item onto the substrate, it can be peeled off reasonably easily. Please allow the adhesive to set if using in heavily trafficked or hazardous areas.
If you are repairing an area which is subject to heavy traffic, you'll need a products thats up to scratch. A repair made with Watco is one that's made to last.All repair