Uses: can be used to highlight external walkways, car park spaces and markings etc. Identify safe or hazardous pedestrian and vehicle areas using colour codes. Smarten up drab, grey asphalt and concrete..Also ideal for tennis courts, playgrounds etc. For garages and vehicle workshops we would recommend one of our epoxy resin coatings such as Watco Safety Coat.

Excellent resistance to UV

Textured surface offers non slip flooring for pedestrians

Can be applied to damp surfaces

No primer required

Watco Safety Blue Anti Slip Traffic Paint is suitable for disabled car park bays (as prescribed in part M of The Building Regulations)

Watco Anti Slip Traffic Paint contains a pre dispersed lightweight aggregate which provides a finely textured anti-slip surface. It produces a more evenly textured finish than conventional anti slip coatings where grit is sprinkled into wet paint. The product is easily applied by roller.

Coverage approx. 15m² per 5 litres, depending on texture of the substrate. One coat is normally sufficient.

Pendulum Slip Test Values
Dry PTV	Wet PTV
66 Extremely low slip potential	52 Low slip potential

Surface Preparation
Watco Anti Slip Traffic Paint can be applied to asphalt, tarmac and porous concrete. Ensure the surface is clean, sound and dry (slightly damp is acceptable). Watco Bio D is a bio degradable solvent free degreaser which can be used on asphalt and similar surfaces. Watco Anti Slip Traffic Paint can be applied to existing paint provided all poorly bonded material is removed and glossy surfaces are dulled using abrasive paper.



Application

Stir contents thoroughly to blend in any settlement. Apply Watco Anti Slip Traffic Paint by brush or medium pile type roller. One coat is generally sufficient although a second coat may be required on very porous or rough surfaces. Avoid applying too thickly. The fine texture may not be immediately apparent as the product is first applied. The texture develops further as the paint dries. Do not apply externally if rain or frost is forecast or if the temperature is below 10°C. The second coat can often be applied after as little as 1 hour depending upon drying conditions.
In exceptional temperature conditions advice should be obtained from Watco’s Technical Department.