Makes slippery floor tiles safe
You may need Watco Safety Tape Edge Sealer if the area will get very wet to help stop water penetrating under the adhesive. One tube is sufficient for approximately 60 Watco Surestep® Tiles.
| Suitable for | Concrete, wood, metal and painted surfaces |
| Finish | Anti slip |
| Interior or Exterior | Exterior, Interior |
| Primer required | To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer |
| Curing time (at 10°C) | 24 hours |
| Minimum application temperature | 10°C |
| Storage | Between 10°C - 30°C |
| Length | 140mm |
| Width | 140mm |
Apply to clean, smooth, dry surfaces such as painted or varnished wood, concrete, metal, tiles, and Terrazzo. Apply direct to smooth, hard concrete; dusty concrete will require a primer.
Smooth, non porous, dust free surfaces do not require priming. To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer.
If appearance is critical we recommend the application of a small trial area first.
Avoid application at temperatures below 10°C. Low temperatures can reduce adhesion. On steps and nosings, apply the product approximately 10mm in from the edge to prevent premature wear and edge curl. Peel back the backing strip approximately 50mm to reveal the adhesive layer. Avoid removing too much of the backing strip, but slowly keep peeling it back whilst firming the product into place. Firming down by hand or foot pressure is generally sufficient.
Although the product can be walked on virtually straight away, the adhesive can take 24 hours to set fully. Immediately after placing the item onto the substrate, it can be peeled off reasonably easily. Please allow the adhesive to set if using in heavily trafficked or hazardous areas.
£13.90 (Ex VAT)
In stock
Increases the adhesion of self-adhesive tapes and treads
From £23.50 (Ex VAT)
Increases the adhesion of self-adhesive tapes and treads
£23.50 (Ex VAT)
