Easy to install alternative covering for areas where repairs can be costly. The quick tile solution for weak, damaged or dangerous floors.
At Watco, we know choosing the right product for the job is of the upmost importance, therefore if you require a sample of any product simply fill in the below form and we will send one out to you. If you require help deciding which product best suits your project, you can speak with our technical experts directly Monday - Friday, 8:00 - 17:30 on 01483 418 418 or alternatively provide as much information as possible and we will contact you.
Our technical advisors are dedicated to providing accurate quotes. If you need a specific quote for your project, please fill in the form below, providing as much detail as you can in the 'Quote Details' box. <br> <br> Alternatively, you can speak with our technical experts directly Monday - Friday, 8:00 - 17:30 on 01483 418 418.
Watco Interlocking Flooring tiles are the ideal solution for covering damaged floor surfaces, where repair can be impractical and expensive. Each tile in the Watco range are simply laid on the surface and tapped into place using a rubber mallet. As no glue is required tiles can easily be moved or replaced at little expense. Watco Interlocking Flooring tiles are manufactured from highly durable PVC to the highest quality standards and are available in a variety of styles, finishes and colours to meet your requirements.
Flat design suitable for vehicular traffic. Raised disc design suitable for pedestrian traffic.
|Usage Interior / Exterior||Interior.|
|Suitable For||Weak or contaminated surfaces which cannot be adequately cleaned to receive a coating.|
|Properties||Anti slip and anti fatigue. Tiles are 500mm x 500mm square and 7mm thick. Edge Ramps are 500mm x 90mm and 7mm thick. Edge Ramp & Corners are 590mm x 90mm and 7mm thick.|
Watco Interlocking Flooring can be installed over any hard surface and in most situations will not require gluing. The only situations where we recommend gluing are where the tiles will be located in direct sunlight (e.g. south facing loading bay) or there will be very heavy traffic movements combined with tight turning circles.
If the installation is to take place when the temperature is cold (below 15°C) it is essential that the tiles are allowed to acclimatise for a minimum of 12 hours. If possible installation should be carried out at a temperature of 18°C+.
If appearance is critical we recommend the application of a small trial area first.
Start installation of the tiles from the middle, working outward towards the sides. This will ensure even distribution of the weight and surface tension of the tiles. The tiles can be connected with a rubber mallet or engineering hammer.
FINISHING AND EDGES
When all full size tiles are laid it is advisable to wait 24 hours before cutting the edge sections. This will allow the tiles to settle and expand fully. Remember to leave a 5mm expansion gap between the tiles and any fixed points (walls, machines etc.) To get the best results when cutting use a table saw, guillotine or jigsaw. We recommend finishing the 5 mm expansion gap between the tiles and the walls with either:
MAKING AN EXTERNAL CORNER
|An external corner piece is available from Watco. Alternatively, the edge ramps can be cut to form a corner as follows:
MAKING AN INTERNAL CORNER