Surestep Walkway is a ready to use roll of anti slip material to identify safe or recommended pedestrian routes through production areas, warehouses etc.

Ideal for identifying recommended pedestrian or visitor routes and emergency escapes

650 x 390mm ‘walking man’ symbol in bright yellow every 5 metres

Can be used inside or out

1m wide roll can easily be trimmed to suit your needs

It is made with hard aluminium oxide grit bonded to a flexible PVC roll in BS5378 Safety Green, and over coated with a tough resin for longer life.

For dusty or porous surfaces, you may need Watco Safety Tape Primer. Allow two packs per 5m x 1m roll.

For very heavily trafficked areas we recommend Watco Safety Grip or Watco Anti Slip GRP Sheet.

Surface Preparation

Apply to clean, smooth, dry surfaces such as painted or varnished wood, concrete, metal, tiles, and Terrazzo. Apply direct to smooth, hard concrete; dusty concrete will require a primer.

Priming

Smooth, non porous, dust free surfaces do not require priming. To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer.

Application
Avoid application at temperatures below 10°C. Low temperatures can reduce adhesion. On steps and nosings, apply the product approximately 10mm in from the edge to prevent premature wear and edge curl. Peel back the backing strip approximately 50mm to reveal the adhesive layer. Avoid removing too much of the backing strip, but slowly keep peeling it back whilst firming the product into place. Firming down by hand or foot pressure is generally sufficient.

Adhesion
Although the product can be walked on virtually straight away, the adhesive can take 24 hours to set fully. Immediately after placing the item onto the substrate, it can be peeled off reasonably easily. Please allow the adhesive to set if using in heavily trafficked or hazardous areas.