New Rapid drying formula can be over coated in 3 hours

Easily applied by roller

Can be used on ceramic tiles before applying a slip resistant coating

Watco Powerfloat Primer enables coatings to be applied to hard, smooth surfaces which would usually reject paint. Avoid using any coating which includes a strong solvent.

Coverage: Approx 30m² per 5 litres

Surface Preparation
New concrete should be allowed at least 28 days to dry. Surfaces should be clean, dry and free from oil, grease, dust, dirt and other contaminants. Existing coatings should be well bonded and sound.

Mixing
The tall outer tin contains a tin of Resin and a tin of Activator. Remove these two tins and stir the contents of each thoroughly. Decant both tins into the tall outer tin. The two components should then be very thoroughly mixed together using a wide bladed stirrer. A wooden batten at least 25mm wide is ideal. Mix for 2 – 3 minutes until an even colour and consistency are obtained.

Application
Decant the mixed components into a roller tray and apply using a medium pile type roller. A brush may be used for cutting in. Aim to apply the mixed components within one hour (they are useable for up to 2 hours maximum at 20°C). Do not apply at temperatures below 10°C or above 30°C. Cold or damp conditions may retard or prevent full curing. Avoid applying too thickly.