Watco Multi Purpose Exterior Paint will smarten up drab concrete, masonry, brick, metal, wood and plastic.

One paint for almost all interior and exterior surfaces

No priming required

Dries quickly to a tough, low sheen film

Dustproofs and colours floors, concrete yards, etc.

Customised colours available

Easy application to walls, doors, steps, guttering, window frames, handrails etc. Provides a uniform colour to stained and defaced yard areas, loading bays, factory and workshop entrances etc.

Coverage approx. 60m² per 5 litres per coat. 2/3 coats are normally required.

Surface Preparation
Ensure surfaces to be painted are clean, dry, free from dust, dirt, grease and any loose material. Previous well-bonded coatings should be abraded before overcoating. All defective or poorly bonded coatings should be removed. Special precautions should be taken during preparation of pre-1960s paint surfaces as they may contain lead. Iron, steel and rusty metals should be primed with Watco Primebase. Thoroughly sweep or lightly abrade bare concrete to remove all loose cement deposits.


Application
Stir thoroughly before use. Apply 2 or 3 coats using brush or roller. When painting very porous surfaces such as bare concrete, brick, render, etc., dilute first coat with up to 20% clean water. Allow each coat to dry thoroughly before overcoating.

Touch dry: 2-4 hours
Recoatable: 4 hours
Fully hard: 7 days (assuming temperatures of at least 15°C and good ventilation.)

Painted floors can be walked on after 16 – 24 hours. Drying time may be considerably extended in cold, poorly ventilated areas or areas of high humidity.