Watco Epoxy Grip Strip is a highly effective and extremely versatile non slip flooring treatment.

Creates a smart, 1mm high, black strip with a charcoal-grey gritted surface

Use on concrete, wood, tiles, marble and other hard or painted surfaces

Ideal for internal and external steps, ramps, entrance ways, around machinery, decking etc

Create any width or length of strip using the special tape provided

An alternative to anti slip tape for a durable finish in heavy wear areas

Extremely durable epoxy resin base with carborundum grit

Ready for traffic in 16 hours

Supplied as an easy to use kit to fit a standard cartridge gun

Strips of Watco Epoxy Grip Strip can give a more attractive finish than a conventional coating. On outdoor steps it also allows rainwater to drain away more easily.

Each pack contains the Cartridge, nozzle, grit and spreader.

Coverage approx. one 310ml tube will provide a line approximately 10m long by 15mm wide.

Surface Preparation
Ensure surfaces are clean and dry. Do not apply to cold (less than 10°C) or damp substrates.


Mixing
Do not mix the epoxy resin paste until you are ready to use it, since it must be applied immediately after mixing.

Each pack contains a tin of curing agent and a separate tin of resin. Add the contents of the curing agent tin to the tin of resin and mix thoroughly using a palette knife or similar. Scrape down the sides and bottom of the tin during mixing to avoid unblended resin/curing agent creating soft spots in the cured product. Once mixed, pour into the 310ml cartridge supplied and close the open end with the plunger. Place the cartridge into the skeleton gun and fit the nozzle once the end has been cut off.

Application

		Lay the Epoxy Grip Strip tape down the desired width apart
		Apply the Watco Epoxy Grip Strip paste evenly between the tapes
		Smooth down the Watco Epoxy Grip Strip paste using the spreader
		Sprinkle Watco Epoxy Grip Strip grit over the pasted area
		Carefully remove the tape before the product cures