The treads are extremely tough; resin bonded aluminium oxide provides a long lasting gritty finish. A flexible aluminium backing conforms to textured surfaces.

Size 610mm x 150mm

Self adhesive – easy to apply

Tough, resin-bonded aluminium oxide provides a long lasting, gritty finish

Water resistant pressure sensitive adhesive backing

Suitable for industrial and commercial use

Helps meet the requirements of the Disability Discrimination Act (DDA) and 2004 Building Regulations

Suitable for internal and external use

You may need Watco Safety Tape Edge Sealer if the area will get very wet to help stop water penetrating under the adhesive.

<

Application Video

Surface Preparation

Apply to clean, smooth, dry surfaces such as painted or varnished wood, concrete, metal, tiles, and Terrazzo. Apply direct to smooth, hard concrete; dusty concrete will require a primer.

Priming

Smooth, non porous, dust free surfaces do not require priming. To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer.

Application
Avoid application at temperatures below 10°C. Low temperatures can reduce adhesion. On steps and nosings, apply the product approximately 10mm in from the edge to prevent premature wear and edge curl. Peel back the backing strip approximately 50mm to reveal the adhesive layer. Avoid removing too much of the backing strip, but slowly keep peeling it back whilst firming the product into place. Firming down using a rubber mallet.

Adhesion
Although the product can be walked on virtually straight away, the adhesive can take 24 hours to set fully. Immediately after placing the item onto the substrate, it can be peeled off reasonably easily. Please allow the adhesive to set if using in heavily trafficked or hazardous areas.