Excellent for general purpose use in factories, showrooms, offices, schools and workshops where the easy removal of dust, dirt, oil and grease is desirable.

Easy to apply and fast drying

Mid-gloss, tile-like finish

Hard-wearing and oil-resistant

Easy to clean

Original, extra strength polyurethane formula transforms and upgrades dusty concrete. If painting new or bare concrete, prepare using Watco Cemtetch.

This floor paint is not recommended for areas where cars may stand for long periods. In common with single pack paints of this type a reaction can take place between car tyres and the paint leading to delamination. We recommend Watco Toughcoat, or a two pack epoxy system such as Watco Epoxy Gloss Coat for such areas.

Coverage approx. 40 m² per 5 litres per coat. Two coats normally required.

Surface Preparation
The concrete should be clean, dry
and free from any loose material and
sufficiently porous to allow the paint
to mechanically bond to the surface.
Previously painted surfaces should be
roughened slightly.
If the concrete is new it should be
left at least 28 days and the surface
then treated with Watco Cemtetch to
neutralise any remaining alkalinity in
the cement.
Watco Cemtetch helps to provide a key on very smooth
surfaces, removes general dirt and
helps to remove laitance (weak, dusty
cement particles) in conjunction with
harsh scrubbing.
Grease and oil should be removed with
Watco Bio D or a similar degreasant.


Application


The paint should be thoroughly stirred.
The paint should not be thinned.
Apply by roller or brush and work well
into the surface. Avoid applying the
paint too thickly.
Apply second coat as soon as the first
coat is dry (approximately 12 hours).
Ensure the paint is hard dry (not just
touch dry) before bringing the area
back into use (generally 16-36 hours).