Uses: An easy and highly effective way to improve safety. Keeps the decorative appearance of surfaces such as
terrazzo - ideal for showrooms, offices or entrance foyers.

# Tough aluminium oxide grit for great slip resistance and long life
# Ideal for indicating hazardous areas or safe escape routes
# Long lasting and consistent colour
# Available in a range of grades and widths

Made from silica particles scattered using static electricity and bonded to clear PVC for a near transparent non slip surface.

Once applied, the appearance is similar to looking through frosted glass.

Surface Preparation

Apply to clean, smooth, dry surfaces such as painted or varnished wood, concrete, metal, tiles, and Terrazzo. Apply direct to smooth, hard concrete; dusty concrete will require a primer.

Priming

Smooth, non porous, dust free surfaces do not require priming. To improve adhesion on weak, dusty surfaces, apply a coat of Watco Safety Tape Primer.

Application
Avoid application at temperatures below 10°C. Low temperatures can reduce adhesion. On steps and nosings, apply the product approximately 10mm in from the edge to prevent premature wear and edge curl. Peel back the backing strip approximately 50mm to reveal the adhesive layer. Avoid removing too much of the backing strip, but slowly keep peeling it back whilst firming the product into place. Firming down by hand or foot pressure is generally sufficient.

Adhesion
Although the product can be walked on virtually straight away, the adhesive can take 24 hours to set fully. Immediately after placing the item onto the substrate, it can be peeled off reasonably easily. Please allow the adhesive to set if using in heavily trafficked or hazardous areas.