Transparent, slightly glossy finish

Minimal darkening

Withstands graffiti removal

An ultra tough, virtually solvent free, two pack polyurethane clear coating which can be applied to almost all surfaces. Any paint or marker pen graffiti that appears later on is easily cleaned off with Watco Graffiti Removal Gel without affecting the substrate.

Coverage approx. 3–4 m² per litre for first coat. 4–6 m² for second coat

Surface Preparation
Ensure surfaces are clean, dry and dust free. Clean off any existing graffiti or it will be sealed in permanently. Any newly applied paint finish must be thoroughly cured before applying Watco Anti Graffiti Coating.


Mixing
Add the curing agent to the resin and mix together thoroughly until a creamy consistency is achieved. Leave for 10 minutes (but no longer). The product is then ready for application.

Application
Apply in dry, warm (above 10ºC) conditions by brush or roller. The second and any subsequent coats should be applied at 6 hour intervals. Spray application is not recommended. When first applied the product may appear ‘milky’ but this will disappear when cured. The surface must be kept dry during curing. We recommend the application of a trial area on decorative surfaces and on surfaces that show efflorescence.