Now you can carry out external decoration at practically any time of the year. Watco All Weather Masonry Paint is a quality exterior paint based on tough Pliolite resin and solvents. It dries quickly, even at low temperatures, and is shower resistant within one hour, making it ideal for use in changeable weather conditions.

Can be applied as low as 5˚C

Touch dry in 1 hour and can be over coated in 4 hours (at 20˚C)

Shower proof in 1 hour at 20˚C, or 2 hours at 10°C

Attractive smooth matt finish

Ideal for use on concrete, cement render, pebble dashed substrates etc.

Permeable to moisture vapour so it allows masonry to breathe

Flexes with surface movement

Coverage: approx. 40m² per 5 litre pack, depending on the porosity and texture of the substrate. Two coats are normally required.

Preparation: brick, masonry, stone and other cementitious surfaces
The application surface should be clean, dry and free of any loose material and contamination. Use a fungicide to remove any fungi, mildew or moss etc. and scrape off any loose paint. Existing hard smooth, glossy paint should be lightly sanded to provide a key. Wash with a detergent solution, rinse with water and allow to dry. Make good any minor defects with an external filler or sand/cement mix.
Preparation: wooden surfaces
All bare wooden surfaces should be clean and dry. Do not apply to door or window frames or previously painted wood, unless all traces of old paint have been removed.


Application

Stir thoroughly before use. Apply two coats using a brush or roller, but on previously painted surfaces in good condition, where similar colours are used, one coat may be sufficient. Allow each coat to dry thoroughly before over coating.