Uses: Ideal to highlight hazards, such as low beams, trip hazards or snag points. Can be used for line marking, walkways or playgrounds.

The thick consistency is easily applied to horizontal or vertical surfaces

Excellent resistance to UV and weathering

Suitable for light to medium traffic

One coat usually sufficient

Flexible, waterproof membrane

Can be applied to damp surfaces

Adheres well to concrete, brick, masonry and asphalt (not metal)

Watco High Visibility Paint is easy to apply by brush or roller, which can be cleaned easily with water.

Coverage approx. 10 – 15m² per 2.5 litres per coat depending upon texture of substrate. One coat is normally sufficient.

Surface Preparationbr>
Watco High Visibility Paint can be applied to asphalt, tarmac, porous concrete, masonry, bricks and breeze blocks. Ensure the surface is clean, sound and dry (slightly damp is acceptable). Watco Bio D is a solvent free degreaser which can be used on most surfaces. Watco High Visibility Paint can be applied to existing paint providing all poorly bonded material is removed and glossy surfaces are dulled using abrasive paper.


Application
Apply Watco High Visibility Paint by brush or medium pile type roller. One coat is generally sufficient although a second coat may be required on very porous or very rough surfaces. Avoid applying too thickly. Do not apply externally if rain or frost is forecast or if the temperature is below 10ºC. The second coat should be applied after approximately 1 hour.

In exceptional temperature conditions advice should be obtained from Watco’s Technical Department.